Civil 3D Apps‎ > ‎

Caltrans A87A Curbs

Caltrans Curbs (A87A)

This subassembly inserts a Curb based on Caltrans 2010 Standard Plan A87A.

  
  
  
  
  

Attachment

This subassembly attachment point is at the Finish Surface of the Curbs, Lips of the Curb and Gutter or at the back of curb.

Input Parameters

Note: All dimensions are in feet unless otherwise noted.

Parameter

Description

Type

Default

Side

Specifies to insert the subassembly either on the right or the left side of the attachment point.

Left / Right

Right

Curb Type

Dictates which Curb Type should be shown.

A1-6/ A1-8/ A2-6/ A2‑8/ A3‑6/ A3‑8/ B1‑4/ B1‑6/ B2‑4/ B2‑6/ B3‑4/ B3‑6/

D‑4/ D‑6/B4/E

A1-6

Attachment Point

Specifies if the attachment point of the assembly, either the back of curb or the FS/Lip of the assembly.

FS or Lip / Back

FS or Lip

Target parameters

None.

Output Parameters

None.

Behavior

This subassembly is intended to provide a way to model Curbs and Gutters.

Layout Mode Operation

In layout mode the subassembly draws the curbs based on the Caltrans Standard Plan for Curbs.

Point, Link, and Shape Codes

The the points, link and shape codes for this subassembly that have codes assigned to them. The point codes and codes vary based on type.

 

Comments